Shot Tec - The Ultimate Hockey Training Device

Rubber Bumper Kit Installation Instructions

Your Rubber Bumper Kit is easily installed in just 3 steps for protection in case of misuse of device. This rubber bumper will make contact with the puck to absorb shock in the chance that an excessive shot is taken.

1. Turn toggle nut clockwise down to the bottom of bolt shaft.
2. Place toggle horizontally at the end of the track (electronic side) and fit it inside the track.
3. Tighten top screw with screwdriver, while holding toggle at a 90 degree angle.

Your rubber bumper kit is now installed!

NOTE: If you have purchased a Shot Tec Device and have not received a Rubber Bumper Kit, please email us at darrin@shottec.com with your mailing address and one will be sent out to you.

 

 

 

The Ultimate Hockey Training Device.

Shot Tec is the World’s First Hockey Training Device that isolates and trains the exact muscle groups required for the perfect shot. If you would like to experience Shot Tec advantages for yourself, Buy Yours Online Now!